Audi Workshop Service and Repair Manuals

Renewing oil seal for selector mechanism in gearbox Special tools and workshop equipment required

t  Tube -VW 423-

t  Extractor tool -T20143/1-

Procedure –  Remove air cleaner housing → Injection and ignition system; Rep. gr.24.

–  Remove securing clip -1-. –  Detach gear selector cable from gearbox selector lever -B-. –  Remove gate relay lever -A- from gearbox together with cable end-piece → Fig.. –  Remove gearbox selector lever -B- by removing nut -arrow 2-.

–  Pry out oil seal using extractor tool -T20143/1-.

–  Drive in oil seal using tube -VW 423-. The remaining installation steps are carried out in reverse sequence; note the following: –  Install gearbox selector lever and gate relay lever → Chapter.   Note The gearbox selector lever can only be installed in one position. –  Install air cleaner housing → Injection and ignition system; Rep. gr.24. Tightening torque → Chapter