A1
Exploded view - clutch release mechanism, slave cylinder |
1 - | Clutch slave cylinder with release bearing |
q | Slave cylinder and release bearing are one unit and can only be renewed together |
q | Do not wash out bearing; wipe clean only |
q | If bearing is noisy, renew together with slave cylinder |
q | Removing and installing → Chapter |
2 - | Bolt |
q | 3x |
q | Renew |
q | Tighten bolts carefully in several small steps and in diagonal sequence; make sure that mounting lugs on slave cylinder do not break off |
q | 12 Nm for metal clutch slave cylinder |
q | 15 Nm for plastic clutch slave cylinder |
3 - | Retaining clip |
q | To remove and install pipe, pull out retaining clip as far as it will go |
4 - | Pipe |
q | To clutch master cylinder |
q | Removing and installing → Chapter |
5 - | Seal |
q | Different versions according to type of connection; for correct version refer to → Electronic parts catalogue |
q | Renew if damaged |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |