A1
Removing and installing input shaft, output shafts, differential and selector rods - exploded view |
1 - | Output shaft for 1st - 4th gear |
q | Dismantling and assembling → Chapter |
q | Installation position → Fig. |
2 - | Selector rod with selector fork for 1st and 2nd gear |
q | Installation position → Fig. |
3 - | Selector rod with selector fork for 3rd and 4th gear |
q | Installation position → Fig. |
4 - | Output shaft for 5th, 6th and reverse gears |
q | Dismantling and assembling → Chapter |
q | Installation position → Fig. |
5 - | Selector rod with selector fork for 5th and 6th gear |
q | Installation position → Fig. |
6 - | Reverse gear selector fork |
q | Installation position → Fig. |
7 - | Input shaft |
q | Dismantling and assembling → Chapter |
q | Always renew grooved ball bearing on input shaft → Item |
8 - | Reverse shaft |
q | With thrust washer |
9 - | Thrust washer |
10 - | Bleeder connection |
q | Connect to slave cylinder → Item |
11 - | Clutch housing |
q | Servicing → Chapter |
12 - | Input shaft oil seal |
q | Renewing → Chapter |
13 - | O-ring |
q | Always renew |
q | Push onto pipe connection |
q | Lubricate with brake fluid before installing |
14 - | Slave cylinder with release bearing |
q | Removing and installing → Chapter |
15 - | Bolt |
q | 3x |
q | Always renew |
q | Tightening torque → Item |
16 - | Countersunk bolt |
q | Removing and installing → Item |
17 - | Flange shaft with spring |
q | Removing and installing → Chapter |
q | Assembling → Chapter |
18 - | Differential |
q | Dismantling and assembling → Chapter |
|