audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Table of shims > < Adjusting output shaft for 1st - 4th gear

A1

Determining thickness of shim
Determining thickness of shim
The specified bearing preload is attained by subtracting the measured value (0.14 mm) from the inserted shim (1.70 mm) and adding a constant value for preload (0.20 mm).
Example:
   
Inserted shim1.70 mm
– Measured value0.14 mm
+ Preload (constant value)0.20 mm
Thickness of shim1.76 mm

–  Determine thickness of shim from table → Chapter.
   
–  Detach gearbox housing and pull tapered roller bearing outer race out of gearbox housing.
A - Counter-support, e.g. -Kukko 22/2-
B - Internal puller 46 ... 58 mm, e.g. -Kukko 21/7-
–  Remove inserted shim (1.70 mm thick) from gearbox housing.
  N35-0332

Table of shims > < Adjusting output shaft for 1st - 4th gear