Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Table of shims >
< Adjusting output shaft for 5th, 6th and reverse gear
A1
Power transmission
6-speed manual gearbox 0A8, front-wheel drive
Gearbox,mechanics,gears,shafts,internal operation
Output shaft for 5th, 6th and reverse gears / justing_output_shaft_for_5th_6th_and_reverse_gear/">Adjusting output shaft for 5th, 6th and reverse gear
Determining thickness of shim
Determining thickness of shim
Determining thickness of shim
The specified bearing preload is attained by subtracting the measured value (0.25 mm) from the inserted shim (1.70 mm) and adding a constant value for preload (0.20 mm).
Example:
Inserted shim
1.70 mm
– Measured value
0.25 mm
+ Preload (constant value)
0.20 mm
Thickness of shim
1.65 mm
–
Determine thickness of shim from table
→ Chapter
.
–
Detach gearbox housing and pull tapered roller bearing outer race out of gearbox housing.
A -
Counter-support, e.g. -Kukko 22/2-
B -
Internal puller 46...58 mm, e.g. -Kukko 21/7-
–
Remove inserted shim (1.70 mm thick) from gearbox housing.
Power transmission
6-speed manual gearbox 0A8, front-wheel drive
Gearbox,mechanics,gears,shafts,internal operation
Output shaft for 5th, 6th and reverse gears / justing_output_shaft_for_5th_6th_and_reverse_gear/">Adjusting output shaft for 5th, 6th and reverse gear
Determining thickness of shim
Table of shims >
< Adjusting output shaft for 5th, 6th and reverse gear