Checking and adjusting selector lever cable |
Checking adjustment of selector lever cable |
–
| Keep button pressed, while pulling selector lever approx. 5 mm to the rear out of position „P“. Then keep lever in this position, do not move it into „R“. |
–
| Release selector lever. |
l
| The selector lever should spring back into position „P“ automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
–
| Shift selector lever into position „N“. |
–
| Keep button pressed, while pulling selector lever approx. 5 mm to the rear out of position „N“. Then keep lever in this position, do not move it into „D“. |
–
| Release selector lever. |
l
| The selector lever should spring back into position „N“ automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
–
| Keep button pressed, while pushing selector lever approx. 5 mm to the front out of position „N“. Then keep lever in this position, do not move it into „R“. |
–
| Release selector lever. |
l
| The selector lever should spring back into position „N“ automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
Adjusting selector lever cable |
|
|
|