audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing valve stem oil seals with cylinder head installed > < Removing and installing camshaft housing

A1

Removing and installing camshaft
Removing and installing camshaft
   
Removing
–  Remove high-pressure pump → Rep. gr.24.
–  Remove camshaft housing → Chapter.
–  Unscrew bolt -1- and remove camshaft clamp -T10414-.
  N15-10549
–  Remove bolts in the sequence -A … J-.
–  Detach retaining frame from camshaft housing.
  N15-10564
–  Pull camshaft -1- out of camshaft housing -2-.
  N15-10565
Installing
l  Tightening torque → Fig. „„Retaining frame for camshaft - tightening torque and sequence““
–  Insert camshaft -1- into camshaft housing -2- (lubricate running surfaces with oil before inserting).
–  Slide camshaft clamp -T10414- into camshaft housing as far as stop and screw bolt in by hand until it makes contact.
–  Fit retaining frame onto camshaft bearing points (note position of dowel pins -arrows-).
  N15-10566
–  Screw in retaining frame bolts by hand until they make contact and then tighten → Fig..
Remaining installation steps are carried out in reverse sequence; note the following:
–  Install camshaft housing → Chapter.
–  Install high-pressure pump → Rep. gr.24.
  N15-10567

Renewing valve stem oil seals with cylinder head installed > < Removing and installing camshaft housing