Audi Workshop Service and Repair Manuals

Removing and installing oil filter bracket Special tools and workshop equipment required

t  Hose clip pliers -VAS 6362-

Removing –  Drain coolant → Chapter. –  Remove alternator → Electrical system; Rep. gr.27.

–  Remove Lambda probe -G39--item 1- → Rep. gr.24.

–  Remove bolts -arrows- and detach heat shield -1-.

–  Release hose clip -1- and detach coolant hose. –  Remove banjo bolt -2-. –  Remove bolt -3- and detach oil supply pipe.

–  Remove bolt -1- and detach oil filter bracket. Installing Installation is carried out in the reverse order; note the following: l  Tightening torques → Chapter „Oil filter bracket and engine oil cooler - exploded view“   Note t  Renew seals, gasket and connecting pipe. t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue. –  Install head shield → Chapter „Turbocharger - exploded view“. –  Install Lambda probe -G39- → Rep. gr.24 –  Install alternator → Electrical system; Rep. gr.27. –  Fill up with coolant → Anchor.