audi Workshop Repair Guides

Audi A1 Workshop Service and Repair Manuals

ABOUT US
Oil filter bracket and engine oil cooler > < Removing and installing drive chain for oil pump

Oil Pump Removal and Installation for 4-Cylinder Petrol Engine

Removing and installing oil pump
Removing and installing oil pump
Special tools and workshop equipment required
   
t  Counterhold tool -T10172-
  W00-1386
Removing
–  Remove sump → Chapter.
–  Unclip cover -1- for oil pump drive chain sprocket.
  N15-10556
–  Slacken off bolt for drive chain sprocket for oil pump several turns -arrow-; use counterhold tool -T10172- to counterhold at drive chain sprocket.
–  Remove bolt and detach drive chain sprocket from chain.
  N17-10018
–  Remove bolts -arrows- and remove oil pump.
Installing
l  Tightening torques → Chapter „Sump, oil pump - exploded view“
  Note
Renew the bolts tightened with specified tightening angle.
–  Check whether dowel sleeves for centring oil pump and cylinder block are fitted; install missing dowel sleeves.
–  Fit oil pump and tighten bolts.
  N17-10021
l  Drive chain sprocket for oil pump can only be installed in one position -arrow-.
Remaining installation steps are carried out in reverse sequence; note the following:
–  Install sump → Chapter.
  N17-10020

Oil filter bracket and engine oil cooler > < Removing and installing drive chain for oil pump