Installation is carried out in the reverse order; note the following:
–
Insert camshafts into camshaft housing (lubricate running surfaces including collar of axial bearing with oil before fitting).
–
Turn the inlet and exhaust camshafts in the removed camshaft housing by hand until the camshaft clamp -T10171 A- can be inserted all the way into the holes in the camshafts.
l
The locking pins -arrows 1- must engage in the holes -arrows 2-.
l
The inscription „TOP“-arrow 3- should be legible from above.
–
To secure the camshaft clamp -T10171 A-, screw in an M6 bolt -arrow- hand-tight, but do not tighten.