audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing bracket for air conditioner compressor > < Removing and installing poly V-belt pulley for crankshaft

A1

Renewing crankshaft oil seal
Renewing crankshaft oil seal
Special tools and workshop equipment required
   
t  Oil seal extractor -3203-
  W00-0062
t  Assembly tool -T10117-
  W00-1275
Procedure
–  Remove poly V-belt pulley for crankshaft → Chapter.
–  Adjust inner part of oil seal extractor -3203- so that it is level with the outer part and lock in position with knurled screw.
–  Lubricate threaded head of oil seal extractor, place it in position and screw it into oil seal as far as possible (applying firm pressure).
–  Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.
–  Clamp flats of oil seal extractor in vice and use pliers to remove oil seal.
–  Remove bearing bush and O-ring from crankshaft journal.
–  Clean contact surfaces for crankshaft chain sprocket and bush.
–  Clean contact surface and sealing surface for oil seal.
  Note
Fit new O-ring.
–  Push bush with O-ring onto crankshaft journal.
  Note
Do not lubricate sealing lip and outer rim of oil seal before pressing in.
  N13-0830
–  Apply guide sleeve -T10117/2- to bearing bush and slide oil seal over guide sleeve.
–  Take off guide sleeve.
  N13-0832
–  Drive in oil seal carefully as far as stop using assembly tool -T10117- and a hammer -arrow-.
Installation is carried out in the reverse order; note the following:
–  Install poly V-belt pulley for crankshaft → Chapter.
  N13-0831

Removing and installing bracket for air conditioner compressor > < Removing and installing poly V-belt pulley for crankshaft