Audi Workshop Service and Repair Manuals

Removing and installing engine mountings Special tools and workshop equipment required

t  Support bracket -10 - 222 A-

t  Adapter -10 - 222 A /19-

t  Engine support bracket (basic set) -T40091-

Removing –  Pull off engine cover panel (front) -arrows- and remove towards front.

–  Remove bolts -1 and 3-. –  Detach air pipe (top right) and push to side.   Note Disregard -item 2-.

–  Remove bolts -arrows-. –  Detach electrical connector -1- for coolant shortage indicator switch -F66- and move coolant expansion tank to side.

–  Position support bracket -10 - 222 A- on top edges of body flanges (left and right) and longitudinal member (right-side), as shown in illustration. –  Attach hook of spindle -10 - 222 A /11- to engine lifting eye. –  Apply light tension to spindle.

–  Remove nut -1- and move earth wire clear. –  Remove bolts -arrows- for support arm of engine mounting.

WARNING Risk of accident. Do not loosen nut -1- unless renewing engine mounting. –  Remove bolts -arrows- and detach engine mounting. Installing Installation is carried out in the reverse order; note the following: l  Tightening torques → Chapter „Assembly mountings - exploded view“   Note Renew the bolts tightened with specified tightening angle.

–  Fit engine mounting on longitudinal member. l  The positioning holes -arrows- must align. If necessary, check with suitable drill bit.

–  Initially screw in bolts -arrows- by hand until they make contact. –  Tighten bolts.   Note Disregard -item 1-.

–  Initially hand-tighten bolts -arrows- for support arm of engine mounting as far as stop. l  The support arm must not turn when you tighten the bolts. –  Tighten bolts.   Note Disregard -item 1-. –  Install air pipe (top right) → Chapter.