audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil pressure switchF1 > < Engine oil cooler - exploded view

A1

Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
  W00-10211
Removing
–  Drain coolant → Chapter.
–  Remove alternator → Electrical system; Rep. gr.27.
–  Remove catalytic converter with centre silencer → Chapter.
  A10-10024
–  Remove bolts -arrows- for coolant pipes at cylinder block and engine oil cooler.
–  Position used oil collection and extraction unit -V.A.G 1782- below engine.
–  Pull coolant pipes forwards out of engine oil cooler.
–  Unscrew bolts -1, 2, 3- and remove engine oil cooler from cylinder block.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter „Engine oil cooler - exploded view“
  Note
Fit new O-rings.
–  Install catalytic converter with centre silencer → Chapter.
–  Install alternator → Electrical system; Rep. gr.27.
–  Fill up with coolant → Anchor.
  Note
The coolant in the entire system must be changed if the engine oil cooler is renewed.
  A17-10342

Removing and installing oil pressure switchF1 > < Engine oil cooler - exploded view