audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing engine mountings > < Assembly mountings

A1

Assembly mountings - exploded view
   
Assembly mountings - exploded view
1 - Engine support
2 - Bolt
q   Tightening torque and sequence → Fig.
3 - Engine mounting
q   Removing and installing → Chapter
4 - Bolt
q   Renew
q   20 Nm + turn 90° further
5 - Support arm
6 - Nut
q   Do not loosen unless renewing engine mounting -item 3-
q   Renew
q   40 Nm + turn 90° further
7 - Threaded pin
q   Renew
q   30 Nm + turn 90° further
8 - Bolt
q   Renew
q   30 Nm + turn 90° further
9 - Pendulum support
10 - Bolt
q   Pendulum support to subframe
q   Tightening torque → Rep. gr.34
11 - Bolt
q   Pendulum support to gearbox
q   Tightening torque → Rep. gr.34
12 - Bolt
q   Gearbox mounting to body
q   Tightening torque → Rep. gr.34
13 - Bolt
q   Gearbox mounting to body
q   Tightening torque → Rep. gr.34
14 - Gearbox mounting
15 - Gearbox support
16 - Bolt
q   Gearbox support to gearbox
q   Tightening torque → Rep. gr.34
17 - Bolt
q   Gearbox support to gearbox
q   Tightening torque → Rep. gr.34
18 - Bolt
q   Gearbox mounting to body
q   Tightening torque → Rep. gr.34

   
Engine support - tightening torque and sequence
  Note
Renew the bolts tightened with specified tightening angle.
  Caution
There is a risk of the engine support breaking due to strain.
It is important that you observe the tightening torque and sequence.
–  Tighten bolts in 3 stages in the sequence shown:
  N13-10321
StageBoltsTightening torque/angle specification
1.-1 … 3-7 Nm
2.-1 … 3-40 Nm
3.-1 … 3-turn 180° further

   

Removing and installing engine mountings > < Assembly mountings