A1
Silencer - exploded view |
1 - | Rear silencer |
q | Align exhaust system so it is free of stress → Chapter |
2 - | Rubber mounting |
q | Renew if damaged |
3 - | Rubber mounting |
q | Renew if damaged |
4 - | Nut |
q | 23 Nm |
5 - | Bolt |
q | 23 Nm |
6 - | Bracket (bottom) |
q | For particulate filter |
7 - | Diesel particulate filter with catalytic converter |
q | Removing and installing → Chapter |
q | After renewing, perform Adaption in Guided Functions → Vehicle diagnostic tester |
8 - | Bracket (top) |
q | For particulate filter |
9 - | Nut |
q | 23 Nm |
10 - | Bolt |
q | 23 Nm |
11 - | Nuts |
q | 9 Nm |
12 - | Heat shield |
13 - | Clamp |
q | For particulate filter |
q | Renew |
q | Installation position → Fig. |
q | 7 Nm |
14 - | Seal |
q | Renew |
15 - | Rubber mounting |
q | Renew if damaged |
16 - | Clamp |
q | Before tightening, align exhaust system so it is free of stress → Chapter |
q | Installation position → Fig. |
q | Tighten bolt connections evenly |
17 - | Nut |
q | 23 Nm |
18 - | Mounting |
q | Renew if damaged |
19 - | Bolt |
q | 23 Nm |
|
|