audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing pump for exhaust gas recirculation coolerV400 > < Removing and installing coolant temperature senderG62

A1

Removing and installing radiator outlet coolant temperature senderG83
Removing and installing radiator outlet coolant temperature sender -G83-
   
Removing
l  Engine cold.
–  Open filler cap -1- on coolant expansion tank briefly to relieve residual pressure in cooling system.
  Note
Disregard -item 2-.
  A19-11169
–  Remove noise insulation -1- → Rep. gr.66.
  A10-11347
–  Unplug electrical connector -2-.
  Note
Place a cloth underneath to catch escaping coolant.
–  Pull off retaining clip -1- and pull radiator outlet coolant temperature sender -G83--item 3- out of connection on coolant pipe.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Fit new O-ring.
t  To avoid loss of coolant, fit new radiator outlet coolant temperature sender -G83- into coolant pipe immediately.
–  Install noise insulation → Rep. gr.66.
–  Check coolant level → Anchor.
  A19-11210

Removing and installing pump for exhaust gas recirculation coolerV400 > < Removing and installing coolant temperature senderG62