audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing charge pressure senderG31 / intake air temperature senderG42 > < Charge air cooling

A1

Charge air cooler - exploded view
   
Charge air cooler - exploded view
1 - Air hose
2 - Air pipe
q   From turbocharger
3 - Spacer sleeve
4 - Bolt
q   9 Nm
5 - Grommet
6 - Air hose
7 - Air duct
8 - Charge air cooler
q   Removing and installing → Chapter
9 - Retainer
q   For charge air cooler
10 - Air hose
11 - Bolt
q   5 Nm
12 - Charge pressure sender -G31-/intake air temperature sender -G42-
q   Removing and installing → Chapter
13 - O-ring
q   Renew
14 - Grommet
15 - Spacer sleeve
16 - Bolt
q   9 Nm
17 - Air pipe
q   To intake manifold

   
Installing air hoses with screw-type clips
  Note
t  Hose connections and air pipes and hoses must be free of oil and grease before assembly.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
t  To ensure that the air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing.
Tightening torque for
1 - Hose clip -a- = 13 mm wide: 5.5 Nm
2 - Hose clip -b- = 9 mm wide: 3 Nm
  A21-10396

Removing and installing charge pressure senderG31 / intake air temperature senderG42 > < Charge air cooling