A1
| Air cleaner - exploded view |
| 1 - | O-ring |
| q | Renew if damaged |
| 2 - | Intake connecting pipe |
| 3 - | Spring-type clip |
| q | Remove and install using hose clip pliers -VAS 6340- |
| 4 - | Intake air duct |
| q | Clean any leaves and dirt out of intake air duct |
| 5 - | Vacuum hose |
| q | Renew if damaged |
| q | To cylinder head cover |
| 6 - | Intake connecting pipe |
| 7 - | Air cleaner (top section) |
| q | Clean any salt residue, leaves and dirt out of air cleaner (top section) |
| 8 - | Bolt |
| q | Tighten to 1.5 Nm using torque screwdriver -VAS 6494- |
| 9 - | Filter element |
| q | Always use genuine part for air filter element |
| q | Removing and installing → Chapter |
| q | Observe change intervals → Booklet819 |
| 10 - | Rubber bush |
| 11 - | Air cleaner (bottom section) |
| q | Clean any salt residue, leaves and dirt out of air cleaner (bottom section) |
| q | Clean water drain |
| 12 - | Bolt |
| q | 8 Nm |
| 13 - | Rubber bush |
| 14 - | Water drain connection |
| 15 - | Intake air duct |
| 16 - | Bolt |
| q | 3 Nm |
| 17 - | Bolt |
| q | 10 Nm |
