1 - | Lambda probe -G39- with Lambda probe heater -Z19- |
2 - | Lambda probe after catalytic converter -G130- with Lambda probe 1 heater after catalytic converter -Z29- |
3 - | Electrical connector for Lambda probe -G39- |
4 - | Electrical connector for Lambda probe after catalytic converter -G130- |
Note t
| Threads of new Lambda probes are already coated with assembly paste; the paste must not get into the slots on the probe body. |
t
| In the case of a used Lambda probe grease only the thread with high-temperature paste. The paste must not get into the slots on the Lambda probe body. High-temperature paste → Parts catalogue |
t
| When installing, the Lambda probe wire must always be reattached at the same locations to prevent it from coming into contact with the exhaust pipe. |
l
| Tightening torque 55 Nm |
Removing and installing Lambda probe -G39- and Lambda probe heater -Z19- → Chapter. |
Removing and installing Lambda probe after catalytic converter -G130- and Lambda probe 1 heater after catalytic converter -Z29- → Chapter |
|
|
|