Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing combustion chamber ring seal (teflon ring seal) >
< Injectors
A1
Power unit
Direct petrol injection and ignition system (4-cyl. 1.4 ltr. 4-valve turbo with timing chain) / Mixture preparation system, electronic inj.,Gas
Injectors
Removing and installing injectors
Removing and installing injectors
Removing and installing injectors
Special tools and workshop equipment required
t
Tool set for FSI engines -T10133-
Removing
–
Remove intake manifold
→ Chapter
.
–
Remove intake manifold (bottom section)
→ Chapter
.
–
Press O-ring by hand upwards (as illustrated) and remove from injector.
–
Screw striker -T10133/3- onto puller -T10133/15-.
–
Then guide puller -T10133/15- into groove
-arrow-
on injector.
–
Pull out injector by knocking carefully.
Note
The combustion chamber ring seal must always be renewed before the injector is re-installed
→ Chapter
.
Power unit
Direct petrol injection and ignition system (4-cyl. 1.4 ltr. 4-valve turbo with timing chain) / Mixture preparation system, electronic inj.,Gas
Injectors
Removing and installing injectors
Renewing combustion chamber ring seal (teflon ring seal) >
< Injectors