A1
Lambda probe and exhaust gas temperature sensors - exploded view |
1 - | Exhaust gas temperature sender 4 -G648- |
q | Removing and installing → Rep. gr.26 |
2 - | Exhaust gas temperature sender 1 -G235- |
q | Removing and installing → Rep. gr.26 |
3 - | Exhaust gas temperature sender 3 -G495- |
q | Removing and installing → Rep. gr.26 |
4 - | Pressure differential sender -G505- |
q | Removing and installing → Chapter |
q | 45 Nm |
5 - | Lambda probe -G39- with Lambda probe heater -Z19- |
q | Removing and installing → Chapter |
q | New Lambda probes are coated with an assembly paste |
q | If you are re-using Lambda probe, coat only thread with high-temperature paste; refer to → Electronic parts catalogue for high-temperature paste |
q | The assembly paste/high-temperature paste must not get into the slots on the Lambda probe body |
q | 55 Nm |