A1
| Wheel bearing housing, wheel bearing unit - exploded view |
| 1 - | Drive shaft |
| 2 - | Suspension strut |
| q | Removing and installing → Chapter |
| q | Servicing → Chapter |
| 3 - | Nut |
| q | 60 Nm +90° |
| q | Always renew if removed |
| 4 - | Bolt |
| q | Threaded end of bolt points in direction of travel |
| q | Always renew if removed |
| 5 - | Bolt |
| q | 8 Nm |
| 6 - | Speed sensor |
| q | Before inserting sensor, clean inside surface of bore and coat with lubricating paste → Electronic parts catalogue „ETKA“ |
| 7 - | Nut |
| q | 20 Nm +90° |
| q | Always renew if removed |
| 8 - | Bolt |
| q | 12 Nm |
| 9 - | Splash plate for brakes |
| 10 - | Track rod ball joint |
| 11 - | Twelve-point nut |
| q | 50 Nm +45° |
| q | Always renew if removed |
| 12 - | Bolt |
| q | Tightening torque → Rep. gr.46 |
| 13 - | Brake disc |
| 14 - | Wheel bearing unit |
| q | The ABS sensor ring is incorporated in the wheel hub |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| q | Renewing → Chapter |
| q | Wheel bearing unit cannot be repaired |
| q | Always renew if removed: will be damaged upon removal |
| 15 - | Wheel bearing housing |
| q | For vehicles with 15" running gear |
| q | Removing and installing → Chapter |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
| 16 - | Wheel bearing housing |
| q | For vehicles with 14" running gear |
| q | Removing and installing → Chapter |
| q | For correct version refer to → Electronic parts catalogue „ETKA“ |
