audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Entry and start authorisation system > < Removing and installing humidity senderG355 - vehicles without main beam assist

A1

Removing and installing humidity senderG355 - vehicles with main beam assist
Removing and installing humidity sender -G355- - vehicles with main beam assist
   
Removing
–  Release retaining clips -4- at mirror base and disengage retaining tabs -2, 3- at cover (front) -1- and then detach cover (rear) -5-.
  A68-10462
–  Detach electrical connector -3- from retainer -2- and unplug.
–  Turn interior mirror at mirror base -1- anti-clockwise -arrow-.
–  Detach interior mirror from retaining plate.
  A68-10463
–  Release retaining tabs -arrows- and carefully fold cover -2- (top) slightly upwards.
–  Disengage retaining tab -1- at cover -3- (front).
–  Detach cover (top).
  A96-10613
–  Disengage retaining hooks -arrows- and pull cover -2- (front) out of guide webs at interior mirror base -1- downwards.
  A96-10647
–  Release retaining clips -2--arrows- and detach humidity sender -G355--item 4- from interior mirror base -1-.
–  Unplug electrical connector -3-.
Installing
l  Tightening torque → Chapter
Installation is carried out in the reverse order; note the following:
–  Install interior mirror → Rep. gr.68.
  A96-10649

Entry and start authorisation system > < Removing and installing humidity senderG355 - vehicles without main beam assist