audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Unplugging door separating connector > < Removing and installing mounting for fuse holder BSB

A1

Removing and installing suppression filterC24
Removing and installing suppression filter -C24-
   
Removing
–  Disconnect earth cable from battery with ignition switched off → Chapter.
–  Remove fuse holder B and move to one side (with wiring connected) → Chapter.
–  Reach below mounting from the side and unplug electrical connector -4-.
–  Carefully release retaining tabs -arrows- and detach cover -1-.
–  Lift suppression filter -C24--item 2- out of mounting -3- by pressing from below.
Installing
Installation is carried out in the reverse order; note the following:
–  Install fuse holder B → Chapter.
  A97-11244

Unplugging door separating connector > < Removing and installing mounting for fuse holder BSB