Notes on releasing and dismantling connector housings |
WARNING Certain tools are equipped with a guard. This is placed over the end of the tool after use to prevent injury to employees and to protect the tip of the tool against damage. |
|
Note t
| Observe general information on repairs to vehicle electrical system → Chapter. |
t
| Always use the release tools intended for this purpose. Never force connectors out of connector housings. |
t
| Always renew damaged connector housings. |
t
| Small screwdrivers can be used to help release secondary locking devices. |
t
| The pin assignment may be stamped on the secondary locking device or on the back of the connector housing. |
|
|
|