A2
Removing and installing lining for bonnet and air intake |
1 - | Bonnet |
2 - | Stop buffer for height adjustment |
q | To adjust bonnet, unscrew stop buffers as far as necessary to make bonnet align with wing panel. |
q | When adjustment is correct, stop buffer should make contact with lock carrier. |
3 - | Locking hook |
4 - | Edge protection |
5 - | Hexagon nut |
q | 15 Nm |
6 - | Spreader rivet |
7 - | Air intake |
q | Remove lining → Item before removing air intake. |
q | Unscrew Torx bolts → Item, pull off spreader rivet and detach air intake. |
8 - | Torx bolt |
q | 3 Nm |
9 - | Lining |
q | To remove, unscrew the three lock washers → Item and detach lining including the six retaining clips from bonnet. |
10 - | Guide |
11 - | Mounting bracket for bonnet |
12 - | Bolt with washer |
q | 15 Nm |
13 - | Lock washer |
Note
|