A2
| Removing and installing window lifter and door window |
| 1 - | Door subframe |
| 2 - | Door window |
| q | Removing: |
| – | Unscrew bolt → Item and open folding hinge → Item. |
| – | Pull window downwards out of guides. |
| q | Installing: |
| – | Insert window in guides and move it up to make contact with seal on B-pillar. |
| – | Raise door window into seal and tighten bolt → Item to 4 Nm. |
| – | Then lower window again. |
| 3 - | Folding hinge |
| 4 - | Torx bolt |
| q | 4 Nm |
| 5 - | Pop rivet |
| q | Observe sequence for riveting. |
| 6 - | Pop rivet |
| 7 - | Pop rivet |
| 8 - | Pop rivet |
| 9 - | Window lifter |
| q | Removing: |
| – | Remove window lifter motor. |
| – | Remove door subframe → Item. |
| – | Drill rivet heads off pop rivets and strike out rivet stems. |
| – | Take rivet stems out of door subframe. |
| q | Installing: |
| – | Rivet window lifter in the following sequence: → Item, → Item, → Item and → Item. |