audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing door arrester > < Door hinges (rear)

A2

Panel gaps
   
Panel gaps
l  Rear door must be adjusted if this has not already been done.
l  Dimension -A- = 3.5 mm ± 0.5 mm
l  Dimension -B- = 4 mm ± 0.5 mm
l  Dimension -A- = 3.5 mm ± 0.5 mm
  Note
t  Use setting gauge -3371- to check panel gaps.
t  The shut lines and panel gaps can be adjusted by loosening the hinge bolts and moving the door.
  A57-0242
Adjusting door at striker plate
  Note
Markings for the precise adjustment of the door are located on the striker plate and on the B-pillar.
–  Slacken bolts -1-.
–  Move striker plate -2- until door shell is flush with contour of body.
–  Tighten bolts.
l  Tightening torque: 20 Nm.
  Note
Use this adjustment only to adjust door inwards or outwards, not vertically.
  A58-0073

Removing and installing door arrester > < Door hinges (rear)