A2
Removing and installing window lifter and door window |
1 - | Door subframe |
2 - | Door window |
q | Removing: |
– | Unscrew bolt → Item and slide window out of pressure plate → Item. |
– | Pull window downwards out of window guides. |
q | Installing: |
– | Insert window in window guides and move it up to make contact with seal on B-pillar. |
– | Raise window into seal until you hear cam engage in pressure plate. |
– | Tighten bolt → Item to 2.5 Nm + 0.5 Nm. |
– | Then lower window again. |
3 - | Pressure plate |
4 - | Torx bolt |
q | 3 Nm |
5 - | Pop rivet |
q | Observe sequence for riveting. |
q | Start riveting window lifter here. |
6 - | Pop rivet |
7 - | Window lifter |
q | Removing: |
– | Remove window lifter motor. |
– | Remove door subframe → Item. |
– | Drill rivet heads off pop rivets and strike out rivet stems. |
– | Take rivet stems out of door subframe. |
q | Installing: |
– | When installing, rivet window lifter first at → Item, then at → Item. |