A2
| Removing and installing front seat backrest |
WARNING
|
| 1 - | Backrest frame |
| q | Remove seat → Chapter. |
| q | Remove seat side trim -5- → Chapter. |
| q | Remove backrest adjuster -12- → Chapter. |
| q | Disconnect airbag cable -7- from seat pan → Chapter. |
| q | Detach heated backrest cable -2- from seat pan. |
| q | Vehicles with no seat height adjuster: |
| q | Unscrew bolts -10- (6x) of seat pan → Chapter. |
| q | Detach holders -9- with bearing shells. |
| q | Fold up seat pan -8- at front. |
| q | Vehicles with seat height adjuster: |
| q | Move seat height adjuster to lowest position. |
| q | All models: |
| q | Remove fitting trim -13- → Chapter. |
| q | Disconnect airbag cable -7- from holder -3- → Chapter. |
| q | Unscrew bolts -11- (4x). |
| q | Detach backrest -1-. |
| 2 - | Seat heater cable |
| 3 - | Holder for seat side trim |
| 4 - | Rivets |
| 5 - | Seat side trim |
| 6 - | Bolts (2x) |
| q | Tightening torque 24 Nm |
| q | To unscrew, heat bolt head for approx. 5 min. with hot air blower -V.A.G 1416/- set to 150° C. Use metal panel to protect cover. |
| q | Slacken off bolt, applying max. 35 Nm with torque wrench. |
| q | If bolt -6- cannot be slackened off, drill into bolt -6- with 5 mm bit and slacken off by drilling anti-clockwise. |
| 7 - | Side airbag cable |
| 8 - | Seat pan |
| 9 - | Holder |
| 10 - | Bolts (6x) |
| 11 - | Bolts (4x) |
| q | Tightening torque 50 Nm |
| q | Screw in bolts -11- at front (round holes) and then at rear (elongated holes). |
| 12 - | Handwheel |
Note| Replace handwheel if it is too loose following assembly. |
| 13 - | Fitting trim |
| 14 - | Bolt |
| q | Tightening torque 2 Nm |
