A2
|
|
1 - | Rear seat bench |
t | Removing |
– | Use awl -V.A.G 1636/- or slotted screwdriver to press wire frame -2- in direction of arrow -A- out of front floor attachments -3- (4x). At the same time, swivel up front edge of rear seat bench in direction of arrow -B-. |
– | Press rear seat bench in direction of arrow -C- and then in direction of arrow -D- and in doing so disengage wire frame -2- from retainer -4-. |
– | Take rear seat bench out of vehicle. |
t | Installing |
– | Position rear seat bench in vehicle. |
– | Engage wire frame -2- in retainer -4-. |
– | Check position of spiral strips at front of wire frame. To prevent noise, spiral strips must be located in area of front floor attachments -3- → Fig. |
– | Press from above onto front edge of rear seat bench until wire frame -2- is heard to engage in front floor attachments -3- (4x). |
2 - | Seat mount wire frame |
3 - | Rear seat bench front floor attachment (4x) |
q | Removing and installing → Chapter |
4 - | Retainer |
5 - | Fixed rear seat backrest |