Removing and installing components of the ABS/ESP system, ITT Mark 60
Removing and installing brake pressure sender -G201- from brake master cylinder
Additionally required information
-
◆ VAS 5051 vehicle diagnostic, testing and information system
Removing
-
‒ Note radio code on vehicles with coded radio; if necessary ask for it.
-
‒ Disconnect and remove battery.
-
‒ Lay out plenty of lint-free cloths in the area of the engine and gearbox.
-
‒ Draw off as much brake fluid as possible from brake fluid reservoir using an extraction bottle.
-
‒ Fit bleeder hose and bleeder bottle to the front left brake caliper bleeder screw and open bleeder screw.
-
‒ Operate the brake pedal at least 15 times so that the brake master cylinder is emptied.
-
‒ Close front left bleeder screw.
|