A2
|
| 1 - | Air conditioner compressor regulating valve -N280- |
| q | Checking actuation and function → Chapter |
| 2 - | Compressor |
| q | Detaching and re-attaching compressor from/onto bracket → Chapter1) |
| q | When installing the refrigerant pipes and the associated bracket, ensure that there is sufficient spacing between the belt, bracket and pulley. |
| 3 - | Pulley1) |
| q | Replacing → Chapter |
| q | Removing and installing the poly-V-belt → Engine Mechanical Components; Repair group 13 |
| q | Poly-V-belt assignment: → Parts List |
Note| t | A rubber element is fitted between the pulley and the drive shaft of the compressor to protect the belt if the compressor becomes jammed or stiff. |
| t | If the compressor is not operating smoothly, the rubber element interrupts the power transmission to the compressor. |
| t | Vibrations occurring during operation of the compressor are dissipated by the rubber element (damper function in the event of torque fluctuations). |
| 4 - | Oil drain plug |
| 5 - | Pressure relief valve |
| 6 - | Connection with valve |
| 7 - | High-pressure sender -G65-1) |
| q | Removing and installing → Chapter |
| q | Checking signal → Chapter |
| 8 - | Condenser |
| 9 - | Screw cap |
| q | with seal |
| q | Must be fitted |
| 10 - | Service connection |
| q | High-pressure side |
| q | For specialist air conditioner workshops for measurement, drainage and filling |
| 11 - | Union in the refrigerant pipe |
| 12 - | Restrictor |
| q | Installed in the threaded connection, Item → Item |
| 13 - | Evaporator |
| 14 - | Service connection |
| q | Low-pressure side |
| q | For specialist air conditioner workshops for measurement, drainage and filling |
| 15 - | Screw cap |
| q | with seal |
| q | Must be fitted |
| 16 - | Reservoir |
