audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Temperature-dependent resistance values of the sensors/senders: > < Test step 1:
Test step 2:
Test step 2:
Temperature sensor and sender
   
Vehicle diagnostic, testing and information system -VAS 5051-, measurement mode: Multimeter, resistance measurement (20 kΩ∼/ 200 kΩ)
l  Adapter -V.A.G 1598/11- connected
Test stepTest box -V.A.G 1598 A- socketBeing tested:
l  Test conditions
–  Additional operations
SpecificationRemedies if specification is not attained
2.133
+
25
Fresh-air intake duct temperature sensor -G89-
l  Ignition off
–  Measure the temperature at the sensor fitting location
t  Governed by the temperature at the sensor/sender fitting location
–  Use current flow diagram to locate and rectify the short circuit, open circuit or contact resistance
2.235
+
25
Evaporator outlet temperature sender -G263-  Temperature-dependent → Chapter
–  Replace the temperature sensor/sender
2.331
+
25
Centre vent temperature sender -G191-    
2.432
+
25
Footwell vent temperature sender -G192-   

   

Temperature-dependent resistance values of the sensors/senders: > < Test step 1: