audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking hydraulic clutch mechanism > < General repair instructions

A2

Servicing clutch mechanism
Servicing clutch mechanism
→ Chapter „Checking hydraulic clutch mechanism“
→ Chapter „Exploded view - pedal cluster“
→ Chapter „Removing and installing over-centre spring“
→ Chapter „Removing and installing clutch pedal“
→ Chapter „Exploded view - hydraulic system“
→ Chapter „Removing and installing clutch master cylinder“
→ Chapter „Removing and installing clutch slave cylinder“
→ Chapter „Bleeding clutch system“
  Note
t  Before renewing the clutch master cylinder or clutch slave cylinder on the assumption that it is defective you must first check the clutch mechanism → Chapter.
t  Disconnect battery earth strap.
t  Note radio coding for vehicles with coded radio.
t  Apply polycarbamide grease -G 052 142 A2- to all bearings and contact surfaces.
t  Make sure that no brake fluid escapes into the footwell, the plenum chamber or onto the gearbox below. If this does happen, clean the affected area thoroughly.
t  Before working on pedal cluster, remove driver's storage compartment → Rep. Gr.68.
   

Checking hydraulic clutch mechanism > < General repair instructions