A2
Servicing clutch release mechanism |
1 - | Release bearing |
q | Do not wash out bearing; wipe clean only |
q | Renew bearing if noisy |
q | Lubricate surfaces which contact release lever with MoS2 grease |
q | Remove and install together with clutch release lever → Item and guide sleeve → Item → Fig. to → Fig. |
2 - | Bolt |
q | 5 Nm and turn 90° further |
q | Always renew |
3 - | Clutch release lever |
q | Remove and install together with clutch release bearing → Item and guide sleeve → Item → Fig. to → Fig. |
q | Lubricate surface which contacts ball head stud with MoS2 grease |
4 - | Retaining spring |
q | Secure to clutch release lever |
5 - | Guide sleeve |
q | Remove and install together with clutch release bearing → Item and clutch release lever → Item → Fig. to → Fig. |
6 - | Input shaft oil seal |
q | Renewing → Item |
7 - | Ball head stud |
q | 20 Nm |
q | Lubricate with MoS2 grease |
8 - | Gearbox |
9 - | Bolt |
q | 23 Nm |
10 - | Bracket |
11 - | Clutch slave cylinder |
q | Removing and installing → Chapter |
q | Lubricate end of plunger with MoS2 grease |
|
|