A2
| Exploded view - clutch mechanism |
| 1 - | Clutch slave cylinder |
| q | Removing and installing with hose/pipe assembly → Chapter |
| q | With clutch travel sender -G162-; -G162- can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
| 2 - | Electrical connector |
| q | For clutch travel sender -G162- |
| 3 - | Bracket |
| q | For clutch slave cylinder |
| 4 - | Bolt |
| q | Secures bracket to gearbox |
| q | 10 Nm |
| 5 - | Lock nut |
| q | For clutch cable |
| q | 15 Nm |
| 6 - | Adjusting nut |
| q | For clutch cable |
| q | Adjusting clutch play → Chapter |
| q | lock after adjusting |
| 7 - | O-ring |
| q | Renew |
| q | Take care not to interchange; for assignment refer to → Electronic parts catalogue |
| q | Distinguishing feature → Fig. |
| 8 - | Assembly plate |
| q | Exploded view → Chapter |
| 9 - | Bracket |
| q | Holds pipe/hose assemblies in position |
| 10 - | Pipe/hose assemblies |
| q | Inserting in gear actuator → Chapter |
| 11 - | Pipe/hose assembly |
| q | Colour of connection piece in mounting plate: „gold“ |
| q | Removing and installing with clutch slave cylinder → Chapter |
| 12 - | O-ring |
| q | Renew |
| q | Take care not to interchange; for assignment refer to → Electronic parts catalogue |
| q | Distinguishing feature → Fig. |
| 13 - | Spring pin |
| q | Renew |
| q | Drive in and drive out with drift |
|
|
| Item | Fitting location | Dimension -a- (mm) | Contour -Arrow- |
| -1- | Clutch slave cylinder | 10 | angular |
| -2- | Hydraulic control unit, gear actuator | 8 | round |