A2
Exploded view of hydraulic control unit, pressure accumulator |
1 - | Accumulator |
q | 40 Nm |
2 - | O-ring |
q | Renew |
3 - | Hydraulic control unit |
q | Can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
q | Removing and installing → Chapter |
4 - | Bolt with washer |
q | 8 Nm |
5 - | Spacer sleeve |
6 - | Bracket |
q | For hydraulic control unit |
7 - | Bolt |
q | 25 Nm |
8 - | Bolt |
q | 10 Nm |
9 - | Rubber bush |
10 - | Pipe/hose assembly |
q | Exploded view → Chapter |
11 - | Pipe/hose assembly |
q | Exploded view → Chapter |
12 - | Pipe/hose assembly |
q | Exploded view → Chapter |
13 - | O-rings |
q | Renew |
14 - | Seal |
q | Renew |
15 - | Seal |
q | Renew |
16 - | Bolt |
q | 8 Nm |
17 - | Bolt |
q | For attaching reservoir to hydraulic control unit |
q | 5 Nm |
18 - | Reservoir |
19 - | Cover |
q | 2 Nm |
20 - | Seal |
q | prevents foreign bodies from entering breather hole in cap during transport |
q | Always to be removed following installation |
21 - | Spring pin |
q | Drive in and drive out with drift |
22 - | Seal |
q | Renew |
23 - | Gearbox hydraulic pressure sender -G270- |
q | Can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
q | Removing wires from connector housing → Electrical system General information; Rep. gr.97 |
24 - | Bolt |
q | 25 Nm |
25 - | Bracket |
q | For attaching hydraulic control unit to body |