A2
| Sealing flanges and flywheel - exploded view of components |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | Oil seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 2 - | Sealing flange (front) |
| q | Removing and installing → Chapter |
| q | Must be positioned on dowel sleeves |
| 3 - | Cylinder block |
| q | Can only be renewed together with crankshaft → Anchor |
| 4 - | Flywheel |
| q | Removing and installing → Chapter |
| q | To remove and install: counterhold with special tool -3386- |
| 5 - | 60 Nm + 90° (1/4 turn) further |
| q | Renew |
| 6 - | Intermediate plate |
| q | Do not damage/bend when assembling |
| q | Must be positioned on dowel sleeves |
| 7 - | 15 Nm |
| 8 - | Sealing flange (rear) with oil seal |
| q | With gasket for cylinder block |
| q | Removing and installing → Chapter |
| q | Install using sealant; sealant → Parts catalogue |
| q | To install, push guide sleeve from installation kit onto crankshaft. |
