A2
Lubrication system - exploded view |
1 - | Cylinder block |
2 - | Gasket |
q | Renew |
3 - | Oil filter bracket |
q | Exploded view → Chapter |
4 - | Bolt |
q | Renew |
q | First fit bolt on top left and bolt on bottom right, then tighten the four bolts diagonally |
q | 14 Nm +90° (1/4 turn further) |
5 - | Seal |
q | Renew |
6 - | Quick release coupling |
7 - | Clip |
8 - | Oil filler reservoir |
9 - | Oil filler cap |
10 - | Seal |
q | Renew |
11 - | Oil filler pipe |
q | To remove, press oil filler pipe toward oil filter bracket and remove clip -item 7-. |
12 - | Oil dipstick |
q | The oil level must not be above max. mark on dipstick |
q | Markings → Anchor |
13 - | Connecting piece |
14 - | Guide |
q | Pull off to extract oil |
15 - | Guide tube for oil dipstick |
16 - | Oil pipe |
17 - | Bolt |
q | 9 Nm |
18 - | Bolt |
q | 9 Nm |
19 - | O-ring |
q | Renew |
q | Oil lightly when fitting |
20 - | Oil level and oil temperature sender -G266- |
q | Illustration shows version fitted up to 04.2002 |
q | Version from 05.2002 → Fig. |
21 - | O-ring |
q | Renew |
q | Oil lightly when fitting |
22 - | Sump |
q | Removing and installing → Chapter |
q | Clean sealing surface before installing |
23 - | Bracket |
q | For air pipe |
24 - | Bolt |
q | 8 Nm |
25 - | Seal |
q | Renew |
26 - | Oil drain plug |
q | 30 Nm |
27 - | Bolt |
q | 15 Nm |
28 - | Baffle plate |
29 - | Bolt |
q | 5 Nm |
|