audi Workshop Repair Guides

Audi Workshop Manuals

< PREV PAGE NEXT PAGE >
Separating catalytic converter and rear silencer
Separating catalytic converter and rear silencer
t  Cutting point is provided in connecting pipe for separate replacement of catalytic converter or rear silencer.
t  The cutting point is marked by an indentation on the circumference of the exhaust pipe.
Special tools and workshop equipment required
   
t  Chain-type pipe cutter -VAS 6254-
  W00-10229
Procedure
–  Unbolt heat shield for exhaust system -arrows-.
  A26-10517
–  Cut through exhaust pipe at a right angle at cutting point -2- using chain-type pipe cutter -VAS 6254-.
–  When reassembling, position the clamp -4- centrally over the markings -1 and 3-.
  A26-0791
–  Install clamp so that bolts are positioned horizontally -arrow-.
l  Bolt connection faces downwards.
l  The thread of the bolt points to left side of vehicle.
Tightening torque
  A26-0365
ComponentNm
Clamp23

   

Power unit > 3-cylinder TDI unit injector engine (1.4 ltr. 2-valve), mechanics > Exhaust system > Removing and installing parts of exhaust system > Separating catalytic converter and rear silencer

< PREV PAGE NEXT PAGE >