A2
Sealing flanges and flywheel - exploded view |
1 - | Bolt |
q | Renew |
q | Tightening torque → Item |
2 - | Crankshaft sprocket |
q | Contact surface between sprocket and crankshaft must be free of oil |
q | Can only be installed in one position |
q | Detach after removing main drive toothed belt → Chapter |
3 - | Poly V-belt pulley for crankshaft |
q | Removing and installing → Chapter |
4 - | Bolt |
q | With washer |
q | For poly V-belt pulley and crankshaft sprocket |
q | Renew |
q | Tightening torque → Item |
5 - | Crankshaft oil seal |
q | Renewing → Chapter |
6 - | Oil pump |
q | Oil pump housing is combined as one unit with sealing flange (pulley end) |
q | Removing and installing → Chapter |
q | When installing note drive cams on crankshaft |
q | Must be positioned on dowel sleeves |
7 - | Gasket |
q | Renew |
q | Must be positioned on dowel sleeves |
8 - | Cylinder block |
9 - | Bolt |
q | Renew |
q | 60 Nm + turn 90° further |
10 - | Flywheel |
q | Removing and installing → Chapter |
11 - | Intermediate plate |
q | Do not damage or bend when assembling |
q | Installing → Fig. |
12 - | Bolt |
q | Renew |
q | Tighten in diagonal sequence |
q | 12 Nm |
13 - | Sealing flange (gearbox end) |
q | With oil seal |
q | Removing and installing → Chapter |
q | Install using sealant; sealant → Parts catalogue |
|
|