audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Enginecrankshaft group, pistons > < Removing and installing engine mountings

A2

Removing and installing pendulum support
Removing and installing pendulum support
   
Removing
–  Release fasteners -arrows- and remove noise insulation.
  A10-0684
–  Remove bolts -arrows- and detach heat shield for drive shaft (right-side).
  A10-0690
–  Remove bolts -arrows- and detach pendulum support.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew the bolts tightened with specified tightening angle.
–  Install heat shield for drive shaft → Rep. gr.39.
–  Install noise insulation → Rep. gr.50.
  A10-0691

Enginecrankshaft group, pistons > < Removing and installing engine mountings