Audi Workshop Service and Repair Manuals > A2 > Power unit | 4-cylinder petrol injection engine (1.4 ltr.), mechanics | Engine cooling | Cooling system | Removing and installing radiator outlet coolant temperature senderG83

Removing and installing radiator outlet coolant temperature senderG83

Removing and installing radiator outlet coolant temperature sender -G83-

Removing

l	Engine cold.

–	Detach bonnet → Chapter.

–	Open filler cap -arrow- on coolant expansion tank briefly to relieve residual pressure in cooling system.

–	Unplug electrical connector -1- at radiator outlet coolant temperature sender -G83-.

Note

Place a cloth underneath to catch escaping coolant.

–	Pull out retaining clip and detach radiator outlet coolant temperature sender -G83-.

Note

Disregard -arrow-.

Installing

Installation is carried out in the reverse order; note the following:

Note

Insert new radiator outlet coolant temperature sender -G83- immediately into connection to avoid loss of coolant.

–	Check coolant level → Anchor.

–	Install noise insulation → Rep. gr.50.

Audi Workshop Service and Repair Manuals