A2
| Silencers - exploded view |
| 1 - | Nut |
| q | Renew |
| q | 40 Nm |
| 2 - | Gasket |
| q | Renew |
| 3 - | Exhaust manifold |
| q | Removing and installing → Chapter |
| 4 - | Lambda probe -G39- |
| q | Removing and installing → Rep. gr.24 |
| 5 - | Rubber mounting |
| q | Renew if damaged |
| 6 - | Centre silencer |
| 7 - | Clamp |
| q | Installation position → Fig. |
| q | Tighten bolt connections evenly |
| q | M8: 23 Nm; M10: 40 Nm |
| 8 - | Nut |
| q | 23 Nm |
| 9 - | Bolt |
| q | 23 Nm |
| 10 - | Mounting |
| q | Renew if damaged |
| 11 - | Rubber mounting |
| q | Renew if damaged |
| 12 - | Rear silencer |
| 13 - | Rubber mounting |
| q | Renew if damaged |
| 14 - | Retainer |
| q | 23 Nm |
| 15 - | Bracket |
| 16 - | Rubber mounting |
| q | Renew if damaged |
| 17 - | Lambda probe after catalytic converter -G130- |
| q | Removing and installing → Rep. gr.24 |
| 18 - | Front exhaust pipe with catalytic converter |
| q | Protect against knocks and impact |
| q | Removing and installing → Chapter |
| 19 - | Bolt |
| q | 23 Nm |
| 20 - | Flexible joint (decoupling element) |
| q | Do not bend more than 10° – otherwise risk of damage |
| q | Use setting tool -T40035- to make sure flexible joint is not kinked. |
|
|
