| Requirements for measurement procedure |
| l
| Ensure that the sliding plates and turntables are not touching the end stop when checking the alignment. |
| l
| Vehicle accurately aligned, suspension bounced and rocked several times |
| l
| The test equipment must be properly adjusted and attached to the vehicle (see equipment manufacturer's instructions). |
| –
| Carry out wheel rim runout compensation. |
Note! | Compensation of wheel rim runout: A certain amount of lateral runout at the wheel rims is permissible, but this may already exceed the specified toe-in tolerance. In such cases it is not possible to correctly set the toe-in without performing the wheel runout compensation. |
|
|
|
