Audi Workshop Service and Repair Manuals > A2 > Vehicle electrics | Electrical system | Instruments, GCI | Dash panel insert | Connection assignment at coolant temperature gauge sender G2 / coolant temperature sender G62

Connection assignment at coolant temperature gauge senderG2/coolant temperature senderG62

Connection assignment at coolant temperature gauge sender -G2-/coolant temperature sender -G62-

Special tools and workshop equipment required

t	Protective cover for bonnet Audi A2 -VAS 6011-

Preliminary work:

–	Wash and rub dry the outside of the bonnet.

–	Release the service flap from inside.

–	Release the bonnet -arrows- and pull it forwards slightly.

–	Fit the protective cover -VAS 6011- over the bonnet.

Note

Do not stand the bonnet on end.

–	Detach the bonnet and set it down on the protective cover -VAS 6011-.

–	Unplug the connector at the coolant temperature gauge sender -G2-:

t	Vehicles with 1.4 l MPI engine → Chapter

t	Vehicles with 1.6 l FSI engine → Chapter

t	Vehicles with 1.2 l TDI engine → Chapter

t	Vehicles with 1.4 l TDI engine → Chapter

Assignment of 4-pin connector at coolant temperature gauge sender -G2-/coolant temperature sender -G62-

1 -	Wiring between coolant temperature gauge sender -G2- and dash panel insert (temperature gauge)

2 -	Earth from coolant temperature gauge sender -G2- (sender earth)

3 -	Earth from coolant temperature sender -G62- (sender earth)

4 -	Signal wire from coolant temperature sender -G62-

Audi Workshop Service and Repair Manuals