–
| Remove the steering column switch → Chapter. |
–
| Unplug the connector at the reading coil. |
–
| Unplug the connector -1- at the ignition/starter switch. |
–
| Remove locking compound from both bolts -arrows-. |
–
| Slacken off the bolts -arrows- slightly and pull the ignition/starter switch out of the steering lock housing -2-. |
Install in reverse order, paying attention to the following: |
Note On installation, make sure the ignition/starter switch and lock cylinder are in the same position, e.g. “ignition ON”. |
–
| Secure bolts -arrows- at steering lock housing -2- with locking compound. |
–
| Fit the steering column switch → Anchor. |
|
|
|