audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Replacing rear light bulbs > < Rear light - exploded view

A2

Removing and installing rear light
Removing and installing rear light
   
Removing
–  Switch off ignition and remove ignition key.
–  Turn light switch to “0” position.
–  Pull the cover -1- out of the luggage compartment side trim -arrows-.
  A94-0252
–  Detach electrical connector -1-.
–  Press locking tabs -arrows- together and remove bulb carrier -2- from rear light in direction of vehicle interior.
  A94-0251
–  Unscrew nuts -arrows-.
–  Detach the rear light outwards from the rear end of the vehicle.
Installing
Install in reverse order, paying attention to the following:
  Note
Ensure tight seal between body and rear light housing.
–  Align rear light to body contours before tightening nuts -arrows-.
–  When doing so, make sure that gap widths are even.
Tightening torque
  A94-0676
ComponentNm
Rear light to body4.5

   

Replacing rear light bulbs > < Rear light - exploded view