audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Unplugging right door disconnectors > < Removing and installing convenience system central control unit J393

A2

Removing and installing right A-pillar connection point
Removing and installing right A-pillar connection point
   
Removing
  Caution
On vehicles with telematics system, activate service mode of telematics control unit before disconnecting battery → Radio, telephone, navigation, self-diagnosis; Rep. Gr.01.
–  With the ignition switched off, disconnect the earth wire at the battery → Chapter.
–  Remove the lower A-pillar trim → Rep. Gr.70.
–  Press the clip in -arrow direction- and disengage the connector point at the A-pillar.
–  Unclip the fuse carriers at the connector point.
–  Detach relays and control units and then unclip the appropriate relay carrier.
  Note
Exact assignment for right A-pillar connection point can be found on applicable current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
Install in reverse order, paying attention to the following:
–  Fit the lower A-pillar trim → Rep. Gr.70.
–  Connect the battery. Action to be taken → Anchor.
  A97-1133

Unplugging right door disconnectors > < Removing and installing convenience system central control unit J393